Construction & Home ImprovementLast reviewed: November 2026

Concrete Footing Calculator

The Concrete Footing Calculator computes concrete volumes and pre-mix bag counts for deck piers, post-frame structures and structural column foundations. It supports cylindrical Sonotubes, isolated square spread pads and continuous trench footings below regional frost lines, so you order the right volume the first time.

Key facts:
  • 6 deck piers (12 in × 3.5 ft) need 0.67 cubic yards, or 31 bags of 80-lb mix.
  • Footings must sit below the local frost line.
  • Sonotubes, square pads and trench footings are all supported.
  • Bell-bottom footings spread the load on weak soil.

Loading calculator…

Share or Export Current Results

Share Concrete Footing Calculator directly or copy link to clipboard

TwitterLinkedInFacebookWhatsApp

Calculation Formula & Mathematical Engine

Theoretical equation governing this computation.

V_{pier} = \pi \times \left(\frac{D}{24}\right)^2 \times Depth_{ft}, \quad V_{pad} = L_{ft} \times W_{ft} \times \left(\frac{T_{in}}{12}\right)

Variable Definitions

V_{pier}Cylindrical Sonotube volume in cubic feet
DDiameter of cardboard Sonotube tube form in inches (8", 10", 12", 16")
Depth_{ft}Total depth of excavation extending below the municipal frost line
V_{pad}Isolated square spread footing pad volume in cubic feet

Step-by-Step Calculation Example

Calculating Concrete for 6 Deck Sonotube Piers (12" Diameter × 3.5ft Deep)

Scenario: A contractor is pouring 6 cylindrical piers below a 42-inch frost line with 10% waste.
Form TypeRound Sonotube Pier
Diameter12 inches (1.0 ft)
Depth3.5 feet (42 inches)
Pier Count6 piers
Execution Steps
  1. 1Radius in feet: 12" ÷ 24 = 0.5 ft
  2. 2Volume per pier: π × (0.5)² × 3.5 = 3.1416 × 0.25 × 3.5 = 2.749 cu ft
  3. 3Total volume for 6 piers: 2.749 × 6 = 16.49 cu ft
  4. 4Add 10% over-excavation allowance: 16.49 × 1.10 = 18.14 cu ft
  5. 5Convert to cubic yards: 18.14 ÷ 27 = 0.67 cubic yards
  6. 6Convert to 80-lb pre-mix bags (0.60 cu ft/bag): 18.14 ÷ 0.60 = 31 bags
Final Verified Output:0.67 Cubic Yards (31 Bags of 80-lb Concrete Mix)

How to Pour a Concrete Footing

Follow these steps to get your result.

  1. 1Measure the footing length, width and depth, and check your local frost line.
  2. 2Enter the dimensions to get the concrete volume and the Sonotube count where used.
  3. 3Dig the footing trench below the frost line and compact the base.
  4. 4Set forms or Sonotubes level, add rebar where specified, and pour the concrete.
  5. 5Screed level, let it cure, and keep it damp for the first few days.

Comprehensive Practical Guide

In-depth analysis, domain guidelines, standard practices, and common pitfalls.

Why Footing Depth Must Exceed the Local Frost Line

When soil moisture freezes in winter, it expands with immense force. If concrete footings are seated above the regional frost depth (which ranges from 12 inches in the southern US to 48+ inches in the northern US and Canada), freeze-thaw cycles will heave the entire structure out of level.

Soil Bearing Capacity and Bell-Bottom Footings

Standard residential soils support 1,500 to 2,000 pounds per square foot (psf). Flaring the bottom of a pier into a "bell" footing (using a BigFoot or plastic footing form) doubles the load-bearing contact area with native undisturbed soil.

Frequently Asked Questions About Concrete Footing Calculator

Direct, verified answers to common calculation and methodology questions.

A 12" × 4' tube holds approximately 3.14 cu ft of concrete, requiring roughly 5.5 to 6 bags of 80-lb concrete mix per pier.
Authoritative Sources & Data References:
  • International Residential Code (IRC Section R403 Footings)
  • American Concrete Institute (ACI 332 Residential Concrete)

Disclaimer: Verify local building department frost depth maps prior to excavation.